Brass Cross Knurled Handle – Diamond-Cut T-Bar Cabinet & Drawer Pull
Size and Fit Guide
Knobs and single hole pulls
Fixed with one screw through the cabinet door or drawer front. Center the knob on the stile or rail, or follow the position of your existing hardware.
Pulls and handles
Pulls are sized by the distance between the centers of their two screw holes (center to center). To replace existing hardware without new holes, measure your current hole spacing and choose the same center to center size. For new cabinets, a common rule is about one third of the drawer width.
Screws and front thickness
Matching screws are included and fit standard cabinet fronts of about 3/4" (19 mm). For thicker fronts or panels, ask us for longer screws before ordering.
Door stoppers and bathroom accessories
Check the mounting surface (floor, wall or baseboard) and the swing of the door before choosing a stopper. Bathroom accessories mount on the wall with the fixings supplied; use anchors suited to your wall type.
Ordering for a whole project?
Email your list or plans to support@studio-timeless.com and we will put the complete order together for you.
Installation Guide
Tools you may need
- Tape measure and pencil
- Drill with a 3/16" (5 mm) bit
- Phillips screwdriver
- Painter's tape or a drilling template
1. Mark the position
Measure and mark the screw holes on the door or drawer front. Use painter's tape to mark without damaging the finish, and repeat the same position on every door for a clean line.
2. Drill
Drill straight through the front from the outside, holding a block of scrap wood behind it to avoid splintering.
3. Fix the hardware
Push the screws through from the inside and tighten them into the knob or pull by hand. Do not overtighten: solid brass threads are precise and do not need force.
Care
Wipe with a soft dry cloth. Avoid abrasive cleaners. Unlacquered brass develops a natural patina over time.
Need help?
Phone: +1 (505) 405-0498
Email: support@studio-timeless.com
Also available on live chat.